Cisco 2960 SI PoE-48 and AIR AP1142N-A-K9 Programmed for a Home Network

By LowVolt
in Smart Home, Network & Security

 Share

Recommended Posts

Grand Master

sc302 Veteran

Posted
  • Veteran
Posted

Not going to happen, sorry. Keep asking and I will lock this up. I will leave this open if there are any questions other than trying to obtain software illegally/without contract.

Apprentice

LowVolt

Posted
  • Author
Posted

Got it. 

 

I legally bought the equipment. I am trying to legally use it. I didn't think requesting some firmware was illegal, obviously I was wrong.

 

No need to jump all over me now and tell me why it's illegal. I could care less. What I did was illegal, I got it.

 

Thanks everyone for your help.

Grand Master

+BudMan MVC

Posted
  • MVC
Posted

You bought the equipment as is did you not.  To get the firmware to use that AP without a controller would require support contract with cisco, ie "smartnet"

 

Where you bought it from - did you not ask them or verify that the AP was able to be used standalone?

 

Tell you what is way cheaper then getting smartnet so you could use the AP standalone.. Just buying some unifi pro devices at 130$ each ;)  You can get the wave 2 units now even for less than what smartnet would cost you..

  • 5 months later...
Neowinian

ebohlman

Posted
Posted

There's a decent chance that the autonomous IOS is on the device already: do a "dir flash:" and see if the image is there (it will have "k9w7" in it). If so, copy the name and do "debug capwap cli". At this point you should be able to get into config mode and enter "boot system flash:<name you copied>". Then save your config and reload.

This topic is now closed to further replies.
 Share
Go to topic listing

  • Recently Browsing   0 members

    • No registered users viewing this page.