Recommended Posts

At completely random times my sata2 hard disk gets undetected causing blue screens and "umountable boot volume" messages at bootup.

I check the BIOS and it is indeed undetected. I have to physically unplug and replug the sata cable for it to be detected and all is fine. Strange though, it only happens with my maxtor sata hard drive.

I've also checked my hard disk's SMART status via speedfan and it says:

NOTE : your hard disk Power On Hours Count attribute current value (241) is below the normal range (243 - 253) reported for your specific hard disk model. Basically your hard disk was powered on for more than the maximum time the average user did. This means that either all of the reports collected are from hard disks that were not powered on for too long (this is realistic for recent models) or that your hard disk is becoming old. Usually this is not considered as a pre-failure advisory, but you should check whether you want to replace the hardware or keep an eye on its performances over time.

NOTE : your hard disk Power Cycle Count attribute current value (250) is below the normal range (252 - 253) reported for your specific hard disk model. Basically your hard disk was power cycled more times than the maximum number the average hard disk was. Power cycles put some stress on the hard disk mechanic. Sometimes power cycles can be caused by a loose hard disk power connector. Make sure it is properly fastened.

Does this sound like a symptom of a loose sata cable or sata power connector?

Any recommendations for a good sata cable in the UK?

Link to comment
https://www.neowin.net/forum/topic/558692-loose-sata-cable/
Share on other sites

maybe you should test your Hard drive with powermax :

http://www.seagate.com/www/en-us/support/d...maxtor_desktop/

and if the test tell that your drive is failling, backup your data and use the warranty ;)

This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.